Product 184 of 228
i-on40 is a 40 zone control unit for hybrid wired/wirefree alarm systems intended for domestic and light commercial use.
The control unit comprises an end station with remote keypads. The
simple-to-install end station has an ABS plastic case which contains
the radio transceiver, power supply and backup battery. Up to four
keypads connect to the end station by standard alarm cable, allowing
the end user to set and unset the system, and the installer to fully
configure the control unit. The keypads also contain integral proximity
tag readers, so that end users can control the system without having to
remember access codes.
The control unit works with Cooper Security Ltd's 700 series 868MHz narrowband wireless peripherals. These include:
During programming the installer can set up the system as either a
part setting system with full set and three part sets, or a partitioned
system where each of the four partitions has full set and a single part
The i-on40 offers a wide range of communication options. Plug-on
modules provide connection to either the telephone system (PSTN), the
mobile phone network (GSM) or the internet via Ethernet or GPRS. In
addition, the control unit provides a set of output pins which can be
used to drive stand-alone communicators.
To make the installation and maintenance simple, the control unit
also provides an Ethernet connector for attaching PCs or laptops. The
control unit can be programmed using a standard web browser from an
Ethernet connected laptop..
40 zone hybrid endstation with remote keypads.
Cooper Security Ltd.
Tested -10 to +55°C.
0 to 75% RH, non-condensing.
384 x 245 x 94, mm HxWxD.
115 x 156 x 34, mm HxWxD
2.2 kg (without stand-by battery).
24 radio, 16 wired.
16 wired (comprising two voltage free contacts, 14 transistorised of which 12 are provided on two separate wiring harnesses).
8 radio (with suitable products such as the 770r Wireless Accessory Module).
±10 minutes over one year (depending on the accuracy of the mains supply frequency).
External Radio Sirens
Up to 1,000 events, stored in flash memory (requires no support battery)
Radio detector differs
4 digits, all four digits may be any number 0 to 9, giving 10,000 differs.
Number of access codes
50 plus installer
Blocked for 90s after four incorrect codes in series.
Proximity tag differs
Operating frequency 868.6625MHz Narrowband.
EN 300 220-3.
EN 300 330-2
The range of the transmitters compatible with this
control unit depends on the environment in which they are installed. As a
guideline, most transmitters will work up 200m range in free space
This product complies with the requirements of EN50131-6 Type A power supply at security grade 2 and environmental class II.
Mains power supply
230VAC +10%/-15%, 170mA max, 50Hz.
End station psu
13.7VDC, 1.5A max
End station consumption
30mA (backlight off)
45mA (backlight on)
65mA (backlight on max)
12V, 7Ah sealed lead acid.
More than 12 hours depending on ancillaries connected to control unit.
Max recharge time:
less than 72 hours.
Battery charge limit
12V Aux supply (inc LS)
13.7VDC +0.1/-0.4 @ 850mA max.
14.4V +0.1/-0.2 @ 230mA
12V Keypad bus
13.7V =0.1/-0.5 @ 400mA max
Mains fail, battery low voltage, battery failure.
Conforms to EN50130-4.
Conforms to EN61000-6-3.
O/P 1 - 2
Voltage free, single pole relay contacts rated 24VDC @ 1A or 120VAC @ 0.5A.
O/P 3 - 4
Open collector transistor, +12VDC when inactive, 0V when active. 500mA max.
O/P 5 - 16
Min impedance 16 Ohm, current consumption from 12VAux = 280mA in alarm.
The control unit has a T250mA mains fuse.
For more information, please visit this product's datasheet.