We recently bought 3 BOSCH Plena tabletop microphones from you.
The connection is a round plug (DIN3 or DIN5 I think it is called).
However, the building is completely wired by Ethernet with RJ45 connectors in each room. The speakers are connect to the room by this method.
Can you advise if you have a convertor to allow us to connect the BOSCH speaker's DIN plugs to the RJ45 sockets.
1
[Ticket Question] Help with a BOSCH Plena tabletop microphone
Started by securitywarehouse, Jan 25 2011 11:19 AM
2 replies to this topic
#2
-
- Administrators
-
- 254 posts
Advanced Member
- LocationUK
Posted 26 January 2011 - 10:28 AM
We will get someone in sales to check this out and get back to you, unless other forum members have suggestions
If you do not wish to post your query on a public forum, please PM one of us. although many questions are of a similar nature, so when posted here it allows others to get advice, and also allows other forum members with knowledge to answer the posts.
#3
-
- Administrators
-
- 254 posts
Advanced Member
- LocationUK
Posted 26 January 2011 - 12:44 PM
The Mic should be run via an independent mic cable as it is sending analogue audio, not data. Also to run on Cat 5 there must be a data receiver at the amplifier end.
Hope this helps you sort it out
Hope this helps you sort it out
If you do not wish to post your query on a public forum, please PM one of us. although many questions are of a similar nature, so when posted here it allows others to get advice, and also allows other forum members with knowledge to answer the posts.
2 user(s) are reading this topic
0 members, 2 guests, 0 anonymous users
